This big 5.5 liter flat 6 is a modified Franklin O-335 aero engine that Tucker used in the Tucker 48 aka the Tucker T...

I added another rotor to the previous model, now it makes over 1900 ft-lbs of torque and over 900 hp. Its crazy, I al...

This started as an experiment on combining a Wankel crank and rotors with a normal reciprocating crank, conrods, pist...

This is the engine I made this morning. 3 liters, 800 or more horsepower, I had to turn the sim frequency down to 600...

new to tuning, upgraded the valves, bore, fuel efficiency, and a bunch more

I made this while trying to make an engine with counter-rotating crankshafts. I gave up after realizing that I couldn...

I tried to simulate a double-expansion engine, where the exhaust of the other two cylinders feed the intake of the la...

2L I4 engine with the i4 journal rod angles. Firing order 1&4-2&3. This thing is very responsive at RPM so you can re...

Its not really offset crank, since with multiple cylinder banks you can't just move the crank position, I had to figu...

I made this today, its 83 cubic inches, 4 cylinders, uses the Hayabusa bore and stroke, and the crankshaft is about 3...

one of the big V10s with a lightweight flywheel and sequential close ratio gearbox

This thing is wacky 2 cylinders fire at the same time it sounds amazing and makes 850 HP at 15500 RPM this thing revs...

makes a little less horse power than stock because of high miles

[Updated on 05 May 2023] The R-4360 was Pratt & Whitney's last aircraft piston engine, as well as the largest and the...

[Updated on 05 May 2023] This was among the largest piston engines ever successfully produced. Design began in early-...