Browse parts

Fixed version of my W16, with the correct vee angle and some exhaust changes to make it less high-pitched. The exhaus...

This is my attempt at a Datsun 100A engine, also known as the engine found inside of the Satsuma AMP from My Summer C...

It's based on the Audi inline 5 and uses some flow settings taken from the 2jz inline-6 aswell, but i have messed aro...

Flat twin cylinder engine made by BMW motorcycles. Note that my code uses another sound than those in the sound_libr...

This is in completely stock form, minus it having a high flowing intake that I coded after a vintage '70's tunnel ram...

Uses same specs as an actual OM606 (although it is a diesel engine). Though I have yet to figure out exact weight an...

Vehicle-connected and upgraded stock i5. Works properly on 15000Hz or below, the crankshaft MUST no-clip for correct ...

W20 9.6 Liters Engine made from 2 x V10 LFA Engines. it was a pain to adjust the cams. If you can run it at 10000 Hz ...

W12 6.6 Liters Engine made from 2 x V6-Even Fire. it was a pain to adjust the cams. Depending on your PC, you might w...

This is my version of Honda's F20c that I started a month ago. It dynos pretty close to the JDM spec of a real F20C. ...

The Hoffmann 3-wheeler was Germany car. And it has 200cc Single Cylinder with 6 hp and 16.5 Nm of torque. 3-speed ma...

[Updated on 02 May 2023] There is very limited information on this engine. It is a one-off engine and it powers 1935 ...

[Updated on 05 May 2023] This is an experimental Ford X8 engine (Sugar Mill experiment #28). I was able to found pict...

This is a full retune of my 608A prime mover it runs better now and idles decently! This makes so much torque it bre...

I got bored and messed around with atg and made a few engines when I was bored, so far this is my favorite. Possibly ...

2814 registered users.
1545 parts by 335 creators.
694 visitors right now. 0 logged in.
1.9m views and 831k downloads.